
This system may be mounted in either a vertical or horizontal position and must be positioned to allow access for service and filter cartridge changing. At the same time, the assembly should be relatively near the spigot to maximize flow rate. The storage tank can be placed on its side without affecting the performance of the system. If there is insufficient room under the sink, the tank may be located in an adjacent cupboard/shelf.
#Mounting Procedure:
Step 1: Mark screw locations at the desired position. Use the two holes on back of purification assemble mounting bracket.
Step 2: Screw wooden screws supplied with unit into marked positions. Leave screw heads out a little.
Step 3: Mount purification assembly onto screws
#Connecting the Water Supply
The water supply connector that comes with the unit is made up of two parts: Water supply connector 1/2" male x ½ female npt.
Step1:Simply disconnect cold water line from angle stop button or from faucet stud on top. Complete with cone-washer and seal.
Step2:Assemble the water supply connector by inserting the delivery valve. Screw the delivery valve into the side of the water supply connector using 3 to 4 wraps of teflon tape.
Step3:Assemble the water supply line from the cold water faucet underneath the sink. Attach and tighten water supply connector assembly being careful not to pinch or crimp any tubing or water supply line while tightening.